Empire Comfort Systems DV-55E-5 Manual De Usuario

Page 12

19563-1-0706

WARNING:  If you do not follow these instructions exactly, a fire or explosion 

may result causing property damage, personal injury or loss of life.

A.   This appliance does not have a pilot.  It is equipped with an 

ignition device which automatically lights the burner.  

 

Do not try to light the burner by hand.

B.   BEFORE OPERATING  smell all around the appliance area 

for gas.  Be sure to smell next to the floor because some gas 

is heavier than air and will settle on the floor.

  WHAT TO DO IF YOU SMELL GAS

•  Do not try to light any appliance.

•  Do not touch any electrical switch; 

  do not use any phone in your building.

•  Immediately call your gas supplier from a neighbor's 

phone.  Follow the gas supplier's instructions.

•  If  you  cannot  reach  your  gas  supplier,  call  the  fire 

department.

C.   Use only your hand to push in or turn the gas control knob.  

Never use tools.  If the knob will not push in or turn by hand, 

don't try to repair it; call  a  qualified service technician.  Force 

or attempted repair may result in a fire or explosion.

D.   Do not use this appliance if any part has been under water.  

Immediately call a qualified service technician to inspect the 

appliance and to replace any part of the control system and 

any gas control which has been under water.

1.   STOP!   Read the safety information above.
2.  Set the thermostat to lowest setting.
3.  Turn off all electric power to the appliance.
4.   This appliance is equipped with an ignition device which 

automatically lights the burner.  Do not try to light the burner 

by hand.

5.  Remove control access panel (front panel).
6.   Turn gas control knob clockwise  

 to "OFF."

7.   Wait ten (10) minutes  to clear out any gas.  Then smell for 

gas, including near the floor.  If you smell gas, STOP! Follow 

"B" in the safety information above.  If you don't smell gas, 

go to the next step.

8.   Turn gas control knob counterclockwise 

 to "ON".

9.   Replace control access panel (front panel). 
10.  Turn on all electric power to the appliance.
11.  Set thermostat to desired setting.
12.  If the appliance will not operate, follow the instructions "TO 

TURN OFF GAS TO APPLIANCE" and  call your service 

technician or gas supplier.

OPERATING INSTRUCTIONS

TO TURN OFF GAS TO APPLIANCE

1.   Set the thermostat to lowest setting.
2.   Turn off all electric power to the appliance if service is to be 

performed .

3.   Remove  control  access panel  (front panel).

4.   Turn gas control knob clockwise  

 to "OFF." Do not 

force.

5.   Replace control  access panel  (front panel).

TOP VIEW