Drolet ECO-45 Manual De Usuario

 

 
A thermostat may help you maintain a constant house temperature 
automatically. A millivolt thermostat or 24 Volt thermostat is 
required. A fixed wall mount or hand held model can be used. The 
control panel can be set up two ways to operate your stove in 
thermostatic mode. 

 
 
• 

Unplug the stove from the power outlet. 

• 

Connect two thermostat wires to the terminal block located on 
the lower right side of the back of the stove. To do so, loosen 
the two screws and insert the wires in the terminals. Tighten 
the two screws. (See figure 16) 

• 

If you are using a wireless wall thermostat or a hand held 
thermostatic remote control, you can locate the receiver behind 
the stove’s back panel, on the right end side, just below the 
terminal block.  Most receivers are already equipped with 
quick-connect terminals.  Simply unplug the PC board wires 
connected to the back of the terminal block and connect them 
directly with the receiver’s terminals.   Location of the 
thermostat is very important to obtain the best comfort and 
efficiency from you ECO-45.  The thermostat should be 
mounted 50 inch from the floor on a wall located 15 to 20  feet 
from the stove.  You should avoid an installation directly in front 
of the stove to avoid cycling.(See figure 17) 

MODES 
 
THERMOSTATIC MODE 
• 

To use this mode, the “MODE” button must be pushed to 
“Thermostat” upon starting the stove. The heat setting is then 
selected using the “Heat Level” selector “+ or –“. When set in 
thermostatic mode, the stove will automatically run a the heat 
level selected until the set room temperature is reached. When 
that occurs, the stove will switch to heat setting #1 (lowest) until 
the thermostat calls for heat again.  The convection blower will 
also slow to its lowest speed. When the thermostat calls for 
heat again, the stove will increase its feed rate to match the 
heat  setting selected.  

 
• 

N.B.:  If the room temperature remains stable and the 
thermostat does not call for heat  during at least 45 minutes, 
the stove will shut down.  When the thermostat calls for heat 
again, the stove will start an ignition cycle.  Once the ignition 
cycle is completed, the stove  will increase its feed rate to 
match the heat  setting selected.  

 
 
NOTE: When in  thermostatic mode: 
 
• 

You should not operate the manual control or play with the 
temperature setting. 

 
• 

YOUR THERMOSTAT SHOULD BE INSTALLED BY AN 
AUTHORIZED DEALER OR SERVICE PERSON. 

 

THERMOSTAT

TERMINAL

 

 
 
 
 

D = MINIMUM DISTANCE 15 FEET

SHOULD BE AVOIDED