Cooper Lighting SA6101-SA6102 Manual De Usuario
Customer First Center • 1121 Hwy 74 South • Peachtree City, GA 30269
IMI-658 ADW051684
Epic/Wall Mounted
Fixtures
Sheet 2 of 4
10/18/05 IMI-658
INSTALLATION INSTRUCTIONS
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
TM
FIXTURE MAINTENANCE
A. Relamping
A. Relamping
Horizontally lamped
1.
1.
Loosen two door screws.
2.
Lower door to tethered resting position. See Figure 4.
3.
Install suitable lamp. Consult re-lamp label and lamp
instructions for details. Do not overtighten.
instructions for details. Do not overtighten.
4.
Raise door and secure with screws.
Vertically lamped
1.
1.
Loosen and remove ring retaining screws globe retaining
ring and globe. Components are not tethered.
See Figure 5. (closeup of lowered globe and ring)
ring and globe. Components are not tethered.
See Figure 5. (closeup of lowered globe and ring)
2.
Install suitable lamp. Consult re-lamp label and lamp
instructions for details. Do not overtighten.
instructions for details. Do not overtighten.
3.
Reinstall ring retaining screws securing globe retaining ring
and globe. In the case of type 3 refractive glass globe, use
the mark on globe bottom for orientation.
and globe. In the case of type 3 refractive glass globe, use
the mark on globe bottom for orientation.
B. Starter and Fuse Replacement (Where applicable)
Horizontally lamped
1.
1.
Loosen two door screws.
2.
Lower door to tethered resting position. See Figure 4.
3.
Loosen thumbscrew until rectangular washer can be rotated
90 degrees. See Figure 6.
90 degrees. See Figure 6.
4.
Rotate reflector faceplate to release from screws using key
hole slots.
hole slots.
5.
Unplug optic quick-disconnect.
6.
Remove two screws on ballast cover followed by ballast
cover. See Figure 7.
cover. See Figure 7.
7.
For starter replacement, remove the plug-in starter from
receptacle and replace.
For fuse replacement, unscrew fuse holder cap and replace
fuse. Resecure fuse holder cap.
receptacle and replace.
For fuse replacement, unscrew fuse holder cap and replace
fuse. Resecure fuse holder cap.
8.
Resecure the ballast cover with the two screws.
9.
Plug optic quick-disconnect and secure reflector by keyhole
slots and thumbscrew.
slots and thumbscrew.
10. Raise door and secure with screws.
Aligning Socket
Fig. 2b
Aligning Pin
Classical Top
Wireway Cover Screws
Fig. 3
Arm Mount
Fixture Screws
Teflon Washers
Wireway Cover
Mounting Hardware
(supplied by others)
(supplied by others)
Traditional Arm
Door
S
crew
s
Fi
g
. 4a
Option
s
Flat Len
s
or
S
a
g
Len
s