Cooper Lighting SA6101-SA6102 ユーザーズマニュアル

IMPORTANT: Read carefully before installing fixture. Retain for future reference.

TM

Horizontally lamped
1.

Loosen two door screws.

2.

Lower door to tethered resting position. See Figure 4.

Install suitable lamp. Consult re-lamp label and lamp 
instructions for details. Do not overtighten.

Raise door and secure with screws.

Loosen and remove ring retaining screws globe retaining 
ring and globe. Components are not tethered.
See Figure 5. (closeup of lowered globe and ring)

Install suitable lamp. Consult re-lamp label and lamp 
instructions for details. Do not overtighten.

Reinstall ring retaining screws securing globe retaining ring 
and globe. In the case of type 3 refractive glass globe, use 
the mark on globe bottom for orientation.

Loosen two door screws.

Lower door to tethered resting position. See Figure 4.

Loosen thumbscrew until rectangular washer can be rotated
90 degrees. See Figure 6.

Rotate reflector faceplate to release from screws using key
hole slots.

Unplug optic quick-disconnect.

Remove two screws on ballast cover followed by ballast 
cover. See Figure 7.

For starter replacement, remove the plug-in starter from 
receptacle and replace.
For fuse replacement, unscrew fuse holder cap and replace 
fuse. Resecure fuse holder cap.

Resecure the ballast cover with the two screws.

Plug optic quick-disconnect and secure reflector by keyhole 
slots and thumbscrew.

10. Raise door and secure with screws.