Siemens CFVA-IP Manual De Usuario
Installing the IP-Module
7. Place the camera body on the IP-Module and screw both units together using
the two screws supplied.
8. Connect the LAN cable to the RJ45 socket (7).
9. Connect the (12 V DC / 24 V AC) electrical supply (8).
9. Connect the (12 V DC / 24 V AC) electrical supply (8).
WARNING
Ensure correct polarity if using a 12 V DC supply, as incorrect connection may
damage the dome camera or cause the unit to operate abnormally.
damage the dome camera or cause the unit to operate abnormally.
10. Establish communication with the device for the first time. See section 7:
11. A test monitor can be connected to the BNC socket (6) when configuring the
camera.
12. Configure the dome camera as required. Refer to the dome camera manual for
set-up instructions.
13. Place the dome back on the camera and screw it in position.
Clean the dome after installation using a soft, lint-free cloth to remove dust and greasy finger marks.
6.2
Installing IP-Module type CVVA-IP
Fig. 2
Exploded view of IP-Module CVVA-IP
12
Siemens Building Technologies
Fire Safety & Security Products