Marantz NR1402 Manual De Usuario
9
Connecting a CD player
• You can enjoy CD sound.
• Select the connector to use and connect the device.
• Select the connector to use and connect the device.
Cables used for connections
Audio cable (sold separately)
Audio cable
R
L
R
L
Optical cable
L
L
R
R
AUDIO
AUDIO
R
L
OUT
OPTICAL
OUT
CD player
Set this to change the digital input connector to which the input
source is assigned.
“Input Assign” (
source is assigned.
“Input Assign” (
)
in Set as Necessary
Connecting an antenna
• Connect the FM antenna or AM loop antenna supplied with the unit
to enjoy listening to radio broadcasts.
• After connecting the antenna and receiving a broadcast signal
with tape in a position where the noise level becomes minimal.
w
e
q
FM outdoor
antenna
antenna
Direction of broadcasting station
75 Ω coaxial
cable
cable
Ground
AM outdoor
antenna
AM loop antenna
(supplied)
Black
White
FM indoor
antenna
(supplied)
n AM loop antenna assembly
1
Put the stand section
through the bottom of the
loop antenna from the
rear and bend it forward.
Stand
Square
hole
Projecting
part
Square
hole
Projecting
part
Loop
antenna
2
Insert the projecting part
into the square hole in
the stand.
n Using the AM loop antenna
Suspending on a wall
Suspend directly on a wall without assembling.
Nail, tack, etc.
Standing alone
Use the procedure shown above to assemble.
NOTE
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect the AM
• Even if an external AM antenna is used, do not disconnect the AM
loop antenna.
• Make sure the AM loop antenna lead terminals do not touch metal
parts of the panel.
• If the signal has noise interference, connect the ground terminal
(GND) to reduce noise.
• If you are unable to receive a good broadcast signal, we recommend
installing an outdoor antenna. For details, inquire at the retail store
where you purchased the unit.
where you purchased the unit.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
or
mation
Basic v
ersion