Tascam SN29401376 Manual De Usuario
Advanced Operations
En-63
■
Network Standby
`
On
`
Off
This setting enables or disables control over the network.
When enabled, the NET indicator will be dimly-lit while
the AV receiver is in standby mode. Note that the indicator
may not light under certain conditions (
When enabled, the NET indicator will be dimly-lit while
the AV receiver is in standby mode. Note that the indicator
may not light under certain conditions (
Note
• When set to “On”, the power consumption slightly increases in
standby mode.
■
Update Notice
`
Enable
`
Disable
When this setting is enabled, you will be notified if a
firmware update via network is available.
firmware update via network is available.
Note
• Selecting “Never Remind me” on the notification window will
switch this setting to “Disable” (
• For details on the update notification, see “If the “Firmware
Initial Setup
If you skipped the initial setup wizard, for example on
first-time use, you can reaccess it from here.
See “Initial Setup” (
first-time use, you can reaccess it from here.
See “Initial Setup” (
Main Menu
Remote Controller Setup
Remote ID
■
Remote ID
`
1, 2, or 3
When several other components are used in the same room,
their remote ID codes may overlap. To differentiate the AV
receiver from other components, you can change its remote
ID from “1”, to “2” or “3”.
their remote ID codes may overlap. To differentiate the AV
receiver from other components, you can change its remote
ID from “1”, to “2” or “3”.
Note
• If you do change the AV receiver’s remote ID, be sure to change
the remote controller to the same ID (see below), otherwise, you
won’t be able to control it with the remote controller.
won’t be able to control it with the remote controller.
Changing the remote controller’s ID
Remote Mode Setup
Main Menu
Lock Setup
With this preference, you can protect your settings by
locking the setup menus.
locking the setup menus.
■
Setup
`
Locked
`
Unlocked
When “Locked” is selected, the setup menus will be
locked and you cannot change any setting.
locked and you cannot change any setting.
Remote Controller Setup
1
While holding down
RECEIVER, press and hold
down
Q SETUP until the remote indicator lights
(about 3 seconds).
2
Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.
The remote indicator flashes twice.
1
2
3
4
5
“Setup”
Lock Setup
1
2
3
4
5
“Setup”