Tascam SN29401376 User Manual

■

`

`

Off 

This setting enables or disables control over the network.
When enabled, the NET indicator will be dimly-lit while 
the AV receiver is in standby mode. Note that the indicator 
may not light under certain conditions (

• When set to “On”, the power consumption slightly increases in 

standby mode.

■

`

Enable 

`

When this setting is enabled, you will be notified if a 
firmware update via network is available.

• Selecting “Never Remind me” on the notification window will 

switch this setting to “Disable” (

➔ page 18).

• For details on the update notification, see “If the “Firmware 

If you skipped the initial setup wizard, for example on 
first-time use, you can reaccess it from here.
See “Initial Setup” (

■

`

1, 2, or 3

When several other components are used in the same room, 
their remote ID codes may overlap. To differentiate the AV 
receiver from other components, you can change its remote 
ID from “1”, to “2” or “3”.

• If you do change the AV receiver’s remote ID, be sure to change 

the remote controller to the same ID (see below), otherwise, you 
won’t be able to control it with the remote controller.

See “Looking up for Remote Control Codes” 
(

➔ page 69).

With this preference, you can protect your settings by 
locking the setup menus.

■

`

`

When “Locked” is selected, the setup menus will be 
locked and you cannot change any setting.

Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.

“Setup”

“Setup”