Windsor 10052250 Manual De Usuario

CUTTER 24V   86039070   04/10/07 

 
The Saber Cutter is a battery powered, self-
propelled, hard floor scrubber intended for 
commercial use.  The appliance applies a 
cleaning solution onto a hard floor, scrubs the 
floor with brushes, and then vacuums the soiled 
water back into the recovery tank. 
 
The machine's primary systems are the solution 
system, scrub system, recovery system, and 
directional control system. 
 
The function of the solution system is to store 
cleaning solution and deliver it to the scrub 
system. The solution system consists of the 
solution tank, strainer, valve and controls.  The 
solution tank stores cleaning solution (water and 
detergent) until it is delivered to the scrub system.  
The strainer protects the valve from debris.  The 
valve is a solenoid type valve, which controls the 
delivery of cleaning solution to the scrub system.  
The valve automatically prevents solution flow 
unless the scrub brushes are turned on and the 
machine is being propelled.  The solution control 
knob controls the amount of cleaning solution 
delivered to the scrub system by controlling the 
amount of time the valve is open. 
 
The function of the scrub system is to scrub the 
floor.  The scrub system consists of two rotary 
type disk scrub brushes, motors, scrub deck skirt, 
lift mechanism and controls.  The brushes scrub 
the floor and the motors drive the brushes.  The 
brush drive hubs allow the scrub brushes to follow 
irregularities and changes in the floor without 
loosing contact with floor.  The scrub deck skirt 
controls the cleaning solution on the floor so that 
the squeegee can pick it up.  The brush lever is 
used to raise and lower the deck. For heavy scrub 
pressure lock the lever into the lower notch. 
Pushing the lever forward allows you to push 
down. Pull Back on the lever to allow it to swing 
down and out of the way. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
The function of the recovery system is to vacuum 
the soiled water back into the recovery tank.  The 
recovery system consists of the squeegee, 
vacuum motor, float ball filter, recovery tank and 
controls.  The squeegee wipes the dirty solution 
off the floor as the machine moves forward.  The 
vacuum motor provides suction to draw the dirty 
solution off the floor and into the recovery tank. 
The recovery tank stores the dirty solution. The 
float ball filter protects the vacuum fan from debris 
and shuts off air going to the recovery tank when 
tank is full. 
 
When flow of air is shut off the vacuum motor will 
continue to run. At this time the recovery tank 
must be drained. 
 
The function of the directional control system is to 
control the direction and speed of the machine.  
The directional control system consists of the 
propel control buttons, reverse button, speed 
control knob/potentiometer, controller and 
transaxle.  The propel control buttons actuates 
switches, which signal forward pressing the 
reverse button in addition to one of the propel 
control buttons the machine will move in reverse.  
The speed control knob actuates a potentiometer, 
which signals speed.  The controller interprets the 
forward/reverse signals from the switches and the 
speed signal from the potentiometer to command 
the transaxle to propel the machine in the 
direction, and at the speed, desired.