Windsor 10052250 Manual De Usuario

 CUTTER 24V   86039070   04/10/07 

 
 
 
7.  BRUSH PRESSURE LEVER 

Adjusts the amount of brush pressure to the floor by 
raising or lowering the scrub deck. 

To apply brush pressure, lower brush pressure lever to 
floating position. 
 
To apply additional pressure, place lever in restricted 
position. Lock the lever into the lower notch.  Push the 
lever forward to move in a downward motion.  Pull back 
on lever and release for floating position. 
 
To decrease brush pressure, raise lever to up position. 

Controls solution flow to scrub deck. 
 
To increase flow, rotate knob clockwise. 
 
To decrease flow, rotate knob counterclockwise. 
 
If the brush motors are turned off or the propel control 
levers are in neutral, the flow is automatically interrupted 
until the motors are turned on again.  This feature 
prevents unintentional draining of the solution tank and 
allows the operator to adjust the solution flow to the 
scrub deck without resetting each time the scrubbing 
operation is interrupted. 

Controls the vacuum motor. 
 
To start vacuum motor, press the bottom of the switch.  
 
To stop vacuum motor, press the top of the switch.

 

Raises and lowers the squeegee. 

To lower the squeegee, lift the lever from its raised 
position. 

To raise the squeegee, lift the lever from its lowered 
position. 

 

 

 

 

 

 

 

 

 

 

 

Adjusts the deflection at the ends of the 
squeegee. 

To increase squeegee blade deflection 
at the ends, turn knob counterclockwise. 

To decrease squeegee blade deflection 
at the ends, turn knob clockwise. 

 

Adjusts the deflection along the entire 
length of the squeegee. 

To increase squeegee blade deflection 
along the entire length, turn the two 
knobs at the squeegee ends counter-
clockwise. 

To decrease squeegee blade deflection 
along the entire length, turn the two 
knobs at the squeegee ends clockwise.