Windsor 10052250 Manual De Usuario

CUTTER 24V   86039070   04/10/07 

Do a pre-run inspection to find possible problems that 
could cause poor performance or lost time from 
breakdown. Follow the same procedure each time to 
avoid missing steps. 
NOTE:  See maintenance section for pre-run machine 
inspection checklist items. 
 

 
1.  Turn the machine power on. 
 
2.  Release the parking brake, if your machine is 

equipped with this option. 

 
3.  Engage the direction propel levers for the desired 

direction. 

 
 

1.  Release the propel levers. 
 

 

2.  Turn machine power off with key switch. 
 
3.  If an electrical problem is suspected push in 

emergency stop button, if machine is equipped 
with this option. 

 
4.  Apply brakes, if your machine is equipped with 

this option. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

FOR SAFETY:  Before leaving or servicing 
machine; stop on level surface, turn off machine 
and remove key. 
 
1.  Turn the machine power off. 
 
2.  Set the parking brake if your machine is equipped 

with this option. 

 
3.  Remove solution tank cover. 
 
4.  Fill the solution tank with clean water, leaving 

enough room for the required amount of cleaning 
solution.  The solution tank capacity filled to 2” (5 
cm) from bottom of fill inlet is 23 gallons (87 liters).  
The water must not be hotter than 140

° F (60°C) 

to prevent damage to the tank. 

 
 
5.  Measure the chemical into the solution tank.  

Liquid chemicals should be added to the solution 
tank after filling with water.  Dry chemicals should 
be thoroughly mixed before being added into 
solution tank.  Commercially available, high 
alkaline floor cleaners, are suitable for use in the

 

solution system.

 

NOTE:  Read the chemical manufacturers 
recommended proportion instructions. 
 

Replace solution tank cover.

 

 
 

Flammable materials can cause an explosion or 
fire.  Do not use flammable materials in the tanks.