Sears 153.33262 Manual De Usuario

24

Before plugging in the water heater, always make sure:
•      The Voltage and frequency correspond to that specified on                                               

       the water heater.
•     The electrical outlet has the proper overload fuse or breaker  

       protection.
•      Unit is to connect to a 120VAC electrical supply outlet      
       (extension cord is not allowed).

Pressure 
Switch

Control Display

Power Supply
Transformer

Igniter/Flame
Sense Connector

Air Intake
Chamber Fan

Anode
Rod

Gas Control 
Valve / Thermostat

FV

Sensor

IMPORTANT: Do not use an extension cord to connect the water 
heater to an electrical outlet.
• 

The water heater and the outlet are properly grounded.

•     Installed in accordance with prevailing provisions of    

 

       local codes, or in the absence of such, National Electric    
       Code, ANSI/NFPS 70 current edition.

Completely fill the tank with water and check all connections for 
leaks. Open the nearest hot water faucet and let it run for three (3) 
minutes to purge the water lines of air and sediment and to ensure 
complete filling of the tank. The electrical power may then be 
turned on. Verify proper operation after servicing.

If this water heater is used as a solar storage heater or as a 
backup for the solar system, the water supply temperatures to 
the water heater tank may be in excess of 120°F. A mixing valve 
or other temperature limiting valve must be installed in the water 
supply line to limit the supply temperature to 120°F.

NOTE: Solar water heating systems can often supply water with 
temperatures exceeding 180°F and may result in water heater 
malfunction.