Baldor iMN1800 Manual De Usuario

2-14 Installation & Operation

MN1800

   Continued

Prior to placing the Forcer on the Platen both surfaces must be cleaned.  
Use this method:

1.

Apply masking tape to lamination surface of the Forcer.  Removing the tape
removes large particle contaminants.

2.

Using alcohol, clean both surfaces to remove any adhesive residue and any
other contaminants on the Forcer and the Platen.

Note: Apply small amount of alcohol to cloth for cleaning.  Never pour or drip alcohol

or other chemicals onto the forcer or platen surfaces.

3.

Wax and polish Platen and Forcer surfaces. ( Turtle Wax ).  Remove any visible
residue.

Cleaning the Air Bearings  Required if the forcer is not lifting between 0.0005

″

 – 0.001

″

 ( i.e. rubbing on the Platen ).

1.

Using a small screw driver, unscrew one air bearing.

2.

Blow compressed air through the bearing in both directions.

3.

Screw the air bearing back to its original position.

Note: Do not mix the air bearings, they have to be installed at their original position.

1.

Before placing the forcer on the platen be sure there is at least 60 psi of
regulated and filtered air flowing through the forcer.

2.

At one end of the platen, carefully slide the Forcer onto the Platen. 
(BE EXTREMELY CAREFUL ).

1.

Before moving the forcer, be sure there is at least 60 psi of regulated and
filtered air flowing through the forcer.

2.

Carefully slide the Forcer to one end of the Platen and remove it. 
(Be Extremely Careful).

Waxing of the Forcer lamination for corrosion protection is recommended every month (or
sooner) depending on environmental conditions (i.e. humidity and moisture).

Operation Considerations The motor must always be operated within the specified operating parameter limits.

Exceeding those limits will permanently damage the motor.

The forcer must never touch the platen during operation.  Equal horizontal and vertical air
gap must be maintained.
The following steps must be completed to ensure safe and proper operation.

1.

Verify that all electrical wiring and cables are properly connected.  Refer to the
manual provided with the control for this information.

2.

Adjust the stepper driver current to match the motor’s current specification.

3.

Strain relieve the wires prior to operating.

Red

1

A+ Winding

Green

2

A– Winding

Yellow

3

B+ Winding

Orange

4

B– Winding

Black

5

Ground

Blue

6

C+ Winding

Green

7

C– Winding

White

8

D+ Winding

Black

9

D– Winding

Red

1

1A+ Winding

Green

2

1A– Winding

Yellow

3

1B+ Winding

Orange

4

1B– Winding

Blue

5

1C+ Winding

Green

6

1C– Winding

White

7

1D+ Winding

Black

8

1D– Winding

Black

13

1Ground

Red

14

2A+ Winding

Green

15

2A– Winding

Yellow

16

2B+ Winding

Orange

17

2B– Winding

Black

18

2C+ Winding

Blue

19

2C– Winding

Green

20

2D+ Winding

White

21

2D– Winding

Black

13

2Ground

9 pin Female to flying leads

25 pin Female to flying leads

Use twisted pairs, shield is open at backshell.

Use twisted pairs, shield is open at backshell.