Tandberg Data LTO-3 HH Manual De Usuario
Tandberg Data
Tape Drive Installation
Tandberg LTO HH Installation and User Manual
7
Do not use longer screws or higher screw torquethan specified!
Longer screws will bottom and not fasten the drive!
Figure 3.3 Mounting screw details
3.6 SCSI Bus Interface
The Tandberg LTO HH tape drive is designed to operate on an Ultra160 low voltage differential
SCSI bus (LVD) with a burst transfer rate up to 160 MB/sec. The Ultra160 SCSI interface is
backward compatible with older SCSI interfaces. Thus all Ultra Wide may be used.
SCSI bus (LVD) with a burst transfer rate up to 160 MB/sec. The Ultra160 SCSI interface is
backward compatible with older SCSI interfaces. Thus all Ultra Wide may be used.
The tape drive features a high density 68-pin (HD-68) connector for attachment to the server or to the
interface connector in an external tabletop cabinet.
interface connector in an external tabletop cabinet.
Attachment to the host computer is described below.
3.7 SCSI Controller Board Installation
Note:
Before any SCSI device can be installed it is necessary to have a SCSI controller board installed.
Please pay attention to the following points.
Please pay attention to the following points.
•
Make sure your computer is turn off before proceeding to the installation.
•
If you computer is equipped with an onboard SCSI controller, before proceeding with the
installation, you must first locate the SCSI connector on the computer motherboard.
installation, you must first locate the SCSI connector on the computer motherboard.
Tape drive's
casting
casting
Wall of server
chassis
Tape drive's
mounting screw
Safe penetration of mounting
screws: min 2 mm, max 2.5 mm