Yamaha RX-V3800 Manual De Usuario

Use this menu to adjust the video parameters.

D

AMP

G

SET MENU

4k

n

l

h

4h

4k

n

l

h

4h

4h

Use the “Video” in “Initialize” to set the parameters in “Manual 
Setup (Video)” (except “Short Message” and “On Screen”) to the 
factory presets (see page 126).

■

Use this feature to activate or deactivate the video scaling 
as well as the HDMI up-conversion of the analog video 
signals input at the composite VIDEO, S VIDEO, and 
COMPONENT VIDEO jacks.

• This unit does not convert 480 line video signals and 576 line 

video signals interchangeably.

• The analog component video signals with 480i (NTSC)/576i 

(PAL) of resolution are converted into the S-video or composite 
video signals and output at the S VIDEO MONITOR OUT and 
VIDEO MONITOR OUT jacks.

• The converted video signals are only output at the MONITOR 

OUT jacks. When recording a video source, you must make the 
same type of video connections between each component.

• When composite video or S-video signals from a VCR are 

converted into component video signals, the picture quality may 
suffer depending on your VCR.

• Even when “Conversion” is set to “On”, HDMI digital signals 

are not converted to analog video signals.

• If “Conversion” is set to “Off”, the “Component I/P”, “HDMI 

Resolution”, “HDMI Aspect”, and “Short Message” features 
are deactivated.

• Set “Conversion” to “On” to display the short message.
• Unconventional signals input at the composite video or S-video 

jacks cannot be converted or may be output abnormally. In such 
cases, set “Conversion” to “Off”.

• When non-standard video signals (such as video signals from a 

video game console) are input, this unit does not display short 
messages on the video monitor even if “Conversion” is set to 
“On”.

• When the analog component video signals with 480p of 

resolution are input at the COMPONENT VIDEO jacks and the 
video monitor is connected to the VIDEO MONITOR OUT or 
S VIDEO MONITOR OUT jack of this unit, the GUI screen is 
not displayed on the video monitor.

• This unit does not up-scale the analog component video signals 

with 720p or 1080i of resolution.

■

Use this feature to activate or deactivate the analog 
interlace/progressive conversion of the analog video 
signals input at the composite video, S-video and 
component video jacks so that the analog video signals 
deinterlaced from 480i (NTSC)/576i (PAL) to 480p/576p 
are output at the COMPONENT MONITOR OUT jacks.

• This menu item is not available and hence not visible in the GUI 

screen if “Conversion” is set to “Off”.

• If your video monitor does not support analog video signals 

with 480p/576p of resolution, the GUI screen may not be 
displayed on your video monitor when “Component I/P” is set 
to “On”. In such a case, set “VIDEO” of “INITIALIZE” in 
“ADVANCED SETUP” parameter to “Off” (see page 126).

Converts composite, S-video, and component 
video signals interchangeably and up-converts 
composite, S-video, and component video 
signals to HDMI video signals.

Off

Does not convert any signals.

On

Activates the analog interlace/progressive up-
conversion of the analog video signals.

Deactivates the analog interlace/progressive up-
conversion of the analog video signals.