Integra DHC-9.9 Manual De Usuario
128
Note:
This procedure can also be performed on the AV control-
ler by using its [Setup] button, arrow buttons, and [Enter]
button.
This procedure can also be performed on the AV control-
ler by using its [Setup] button, arrow buttons, and [Enter]
button.
Mac Address
This is the AV controller’s MAC (Media Access Control)
address. This address cannot be changed.
address. This address cannot be changed.
Control
This setting enables or disables control over the network.
Enable: Control over the network enabled.
Disable: Control over the network disabled.
Port
This is the network port used for control over the net-
work.
work.
DHCP
This setting determines whether or not the AV controller
uses DHCP to automatically configure its IP Address,
Subnet Mask, and Gateway settings.
uses DHCP to automatically configure its IP Address,
Subnet Mask, and Gateway settings.
Enable: DHCP enabled.
Disable: DHCP disabled.
If you select “Disable”, you must configure the “IP
Address”, “Subnet Mask”, and “Gateway” settings your-
self.
Address”, “Subnet Mask”, and “Gateway” settings your-
self.
IP Address
If you set the “DHCP” setting to “Disable”, you must
specify an IP address. Enter a static IP address provided
by your ISP.
The IP address must be within the following ranges.
specify an IP address. Enter a static IP address provided
by your ISP.
The IP address must be within the following ranges.
Class A: 10.0.0.0 to 10.255.255.255
Class B: 172.16.0.0 to 172.31.255.255
Class C: 192.168.0.0 to 192.168.255.255
Most routers use Class C IP addresses.
Subnet Mask
If you set the “DHCP” setting to “Disable”, you must
specify a subnet mask address.
Enter the subnet mask address provided by your ISP
(typically: 255.255.255.0).
specify a subnet mask address.
Enter the subnet mask address provided by your ISP
(typically: 255.255.255.0).
Gateway
If you set the “DHCP” setting to “Disable”, you must
specify a gateway address.
Enter the gateway address provided by your ISP.
specify a gateway address.
Enter the gateway address provided by your ISP.
Lock
With this setting, you can protect your settings by lock-
ing the setup menus.
ing the setup menus.
Locked: Setup menus locked.
Unlocked: Setup menus unlocked (default).
When Locked is selected, only this “Lock Setup” item
can be accessed.
can be accessed.
3
Use the Up and Down [
q]/[w] but-
tons to select “6. Network”, and
then press [Enter].
The “Network” screen appears.
then press [Enter].
The “Network” screen appears.
4
Use the Up and Down [
q]/[w] but-
tons to select the settings, and
use the Left and Right [
use the Left and Right [
e]/[r]
buttons to set them.
To enter an IP address, select the set-
ting, and then press [Enter]. The arrow
[
To enter an IP address, select the set-
ting, and then press [Enter]. The arrow
[
q]/[w]/[e]/[r] buttons can then be
used to enter numbers. Press [Enter]
again to set the number.
The settings are explained on the next
page.
again to set the number.
The settings are explained on the next
page.
5
When you’ve finished, press the
[Setup] button.
Setup closes.
[Setup] button.
Setup closes.
Enter
Enter
7-6. Network
MAC Address
Control
Control
Port
xx : xx : xx : xx : xx : xx
Enable
xxxxx
MOVE
VALUE
INPUT
RETURN
ENTER
RETURN
EXIT
SETUP
Enter
Setu
p
Lock Setup