Bang & Olufsen 8002 Manual De Usuario

–  Disconnect your system from the 

mains supply. 

–  Place the loudspeakers in your 

setup. 

–  Set the switches to the correct 

setting. This is explained in ‘Adapt 

the loudspeakers to your setup’ 
(page 6). 

–  Connect your speaker system. 
–  Connect the entire system to the 

mains again. 

If you mount the loudspeaker on a 
wall bracket, you cannot assemble 

the base to the loudspeaker. 

–  Make sure that the loudspeakers 

are placed and connected in 
accordance with the instructions 
in this Guide. To prevent injury, 
use Bang & Olufsen approved 
stands and wall brackets only! 

–  The loudspeakers can only be 

switched off completely by 
disconnecting them from the 
wall socket. 

–  The loudspeakers are designed 

for indoor use in dry, domestic 
environments only, and for use 
within a temperature range of 

10–40º C (50–105º F). 

–  Remember that all speakers in a 

setup must be connected to a 
mains outlet, and that they are 
designed to be connected to the 
mains at all times, as this allows 

them to switch on automatically. 

–  Do not attempt to open the loud­

speaker. Leave such operations 

to qualified service personnel! 

Column and base
It is easiest to assemble the base and 
the speaker column if the loud­
speaker is placed on the two foam 

packaging blocks – as shown. 

Remove the small plastic cylinder 
from the threaded end of the loud­
speaker, and push the base onto 
the threaded end. Fasten the base 
to the column with the washer and 
nut. Tighten the nut carefully. 

4

NOTE! The type number of the 
loud speaker appears on the label 
which is placed on the inside of the 
socket panel cover.