3com DSA-3CV1100-02 Manual De Usuario
Central Management
103
To close the Telnet session, type
y
and press <Enter>.
The message appears:
The action has been done
A message regarding session close does not appear on the Telnet screen.
To cancel session close, type
n
and press <Enter>.
The message appears:
The action has been canceled
The default is
n
.
Set Factory Defaults
To restore the user password and network parameters to the factory
defaults, type
defaults, type
4
in the Agent Configuration Menu (
) and press
<Enter>.
The messages appear:
This action will return the system parameters to their
default values
Do you want to proceed (Y/[N])? :
Confirm or discard the change:
■
To confirm,
a Type
y
and press <Enter>.
The messages appear (
Figure 80 Factory Defaults are Set
for Line Card 1)
or the management agent (refer to
).
The factory’s default settings were written to the
non-volatile memory
Note: some of the changes will take effect just after reset
Press ENTER to continue ...