RCA L37WD23 Manual De Usuario

There are three ways to program the remote control to operate other 
devices: Direct Entry, Manual Code Search, and Automatic Code 
Search. If you have recently purchased the device you want to control 
or if the device has many codes, you might want to try the manual 
code search fi rst.

1.  Turn on the device you want to control.

2.  Look up the brand and code number(s) for the device in the code 

list at the end of this section.

3.  On your remote control, simultaneously press and hold the 

ON•OFF and MUTE buttons (approximately 3 seconds) until a 
device button remains lit. Then release the buttons.

4.  Press and release the device button (SAT•CBL or DVD•VCR) you 

want to program. 

5.  Enter a three digit code from the code list.  

6.  To test the code you’ve programmed for that device button, point 

the remote at the device and then press ON•OFF to see if the 
device responds to the remote control. 

 

If the device turns off, you’ve entered the correct programming 
code for your device. Circle the code you entered for future 
reference.

 

If the device doesn’t turn off, repeat these steps until you’ve tested 
all codes for your device’s brand or try to run a manual code 
search.

1.  Turn on the device you want to control.

2.  On your remote control, simultaneously press and hold the ON•OFF and MUTE buttons 

(approximately 3 seconds) until a device button remains lit. Then release the buttons.

3.  Press and release the device button (SAT•CBL or DVD•VCR) you want to program.

4.  Repeatedly press and release the ON•OFF button, watching for the device to respond. 

If it does turn off, press and release the OK button within 3 seconds to save the code. If 
you accidentally passed the code before saving it, press the left arrow button to backtrack 
through the codes; then use the right arrow button to go forward through the codes again.

When all codes have been searched, the device button fl ashes 3 times, then the remote exits 
manual code search and returns to normal operation.

1.  Turn on the device you want to control.

2.  On your remote control, simultaneously press and hold ON•OFF and MUTE 

(approximately 3 seconds) until a device button remains lit. Then release the buttons.

3.  Press and release the device button you want to program.