RCA L37WD23 Manual De Usuario

4.  Press and release the ON•OFF button once. There is a delay of approximately 6 seconds 

before the remote starts the code search.

 

The device buttons blinks each time the remote control sends a code to test with your 
device. Keep pointing the remote at the device.

5.  Once the device turns off, quickly press the OK button to save the code.

6.   If you accidentally passed the code before saving it, press the left arrow button to back-

track through the codes; then use the right arrow button to go forward through the codes 
again.

When all codes have been searched, the device button fl ashes 3 times, then the remote exits 
automatic code search and returns to normal operation.

Once the remote has been programmed successfully, you are ready to use it to operate your 
devices. 

To operate the device:

1.  Press the appropriate device button (SAT•CBL or DVD•VCR) to set the remote to control 

the device, for example, press DVD to control your DVD player.

2.  Press ON•OFF to turn the device ON or OFF.

3.  Use the remote buttons that apply to that device.

The button corresponding to the mode the remote is in lights up when you press any button 
that works in that mode. For example, if you’re in TV mode and you press the VOL+ button, 
the TV button lights up. This tells you that the command to increase the volume is being sent to 
the TV (and not the satellite receiver, for example).

You may fi nd this feature helpful if you’ve connected your devices to an audio system, and you 
want to use the TV’s remote control to operate the volume for a device that is connected to the 
audio system. An example follows:

Let’s say you’ve connected your DVD player to your audio system. You’ve also programmed 
your TV remote control to operate your DVD player. Since the DVD player sends its volume 
through the audio system, you would have to use the audio system’s remote to adjust the 
volume and the TV’s remote control to operate the DVD player. The Volume Punchthrough 
feature eliminates the need for you to use two remote controls and saves a button press when 
you’re using the TV remote to adjust the volume. 

After you’ve successfully set up the Volume Punchthrough feature, whenever the TV remote 
is in DVD mode (press the DVD button) and you want to adjust the volume, you only have 
to press the VOL +/- or MUTE buttons. Follow the instructions below to set up Volume 
Punchthrough.