Husqvarna 966451906 Manual De Usuario

English - 

21

Safety equipment

Dismantle the ignition module as outlined in 

“7.7 Dismantling the ignition module and flywheel”. 

Cut open the shrink tube covering both cables and 

shrink tubing that encloses the cable ends. 

Clean the contact areas and check resistance in 

the following way:

Test the resistance by connecting a multimeter to 

the cable ends. NOTE! The power switch must be 

in the “on” position to get the correct reading. See 

figure 17.

The stop switch is in the “on” position when the 

button is held down (see figure 17) and in the “off” 

position when the button is in neutral.

Resistance can be 0.5 Ohm at most with the power 

switch in the “on” position.

When assembling (see figure 18), pull the cable 

ends apart and slide on a thicker shrink tube over 

both cables. Then slide on the thinner shrink tubes 

over each cable. Connect the cable ends together. 

Slide the thinner shrink tubes over the cable ends 

and heat the shrink tube first on both cables sepa-

rately. Slide the thicker shrink tube over the thinner 

shrink tubes and then heat the thicker shrink tube. 

Fit the new stop control (A) and tighten screw (B) in 

place at a torque of 1 Nm. Slide in the stop control 

in the rubber sleeve C and hook the sleeve on the 

guide taps. See figure 15.

Fig 15

Fig 16

Attach the cables as outlined in figure 16.

Attach the air filter holder. See the “Assembling the 

carburettor” chapter. 

Fit air filter and cylinder cover.

Fig 18

Fig 17