Jonsered CS 2171WH Manual De Usuario

English

 – 27

Starting: The chain brake must be engaged when the chain 
saw is started. Activate the brake by moving the front hand 
guard forwards.

Ignition: Slide the ignition switch to the left.

Choke: Set the choke control in the choke position.

Start throttle: The correct choke/start throttle setting is 
obtained by moving the control to the choke position.

If the machine is fitted with a decompression valve (A): Press 
the valve to reduce the pressure in the cylinder and make 
starting easier. You should always use the decompression 
valve when starting the machine. Once the machine has 
started the valve will automatically return to its original 
setting.

Use the same procedure as for starting a cold engine but 
without setting the choke control in the choke position. The 
correct choke/start throttle setting is obtained by moving the 
choke control to the choke position and then pushing it in 
again.

Grip the front handle with your left hand. Hold the chain saw 
on the ground by placing your right foot through the rear 
handle. Pull the starter handle with your right hand and pull 
out the starter cord slowly until you feel a resistance (as the 
starter pawls engage) then pull firmly and rapidly. Never twist 
the starter cord around your hand.

CAUTION! Do not pull the starter cord all the way out and do 
not let go of the starter handle when the cord is fully extended. 
This can damage the machine.

Push in the choke control as soon as the engine fires and 
keep pulling until the engine starts. When the engine starts, 
quickly apply full throttle; the throttle start lock will 
automatically disengage.

As the chain brake is still engaged the speed of the engine 
must be set to idling as soon as possible, this is achieved by 
quickly disengaging the throttle lock. This prevents 
unnecessary wear to the clutch, clutch drum and brake band.