Black Box MPSH16-D20-120V Manual De Usuario
CHAPTER 5: Configuration
67
5.9.1. Network Port Parameters
In the Text Interface, these parameters are found in the main Network Configuration
In the Text Interface, these parameters are found in the main Network Configuration
menu In the Web Browser Interface, these parameters are found by placing the
cursor over the "Network Configuration" link on the left hand side of the screen, and
then clicking on the "Network Port Parameters" link in the resulting fly-out menu.
• Administrator Mode: Permits/denies port access to accounts that allow
Administrator or SuperUser level commands. When enabled (Permit), the
port will be allowed to invoke Administrator and SuperUser level commands,
providing they are issued by an account that permits them. If disabled (Deny),
then accounts that permit Administrator and SuperUser level commands will not
be allowed to access command mode via this port. (Default = Permit)
• Logoff Character: Defines the Logoff Character for this port. This determines
which command(s) must be issued at this port in order to disconnect from a
second port. (Default =
^X ([Ctrl] plus [X]).)
Note:
The Sequence Disconnect parameter can be used to pick a one
character or a three character logoff sequence.
character or a three character logoff sequence.
• Sequence Disconnect: Enables/Disables and configures the Resident
Disconnect command. Offers the option to either disable the Sequence
Disconnect, or select a one character, or three character command format.
(Default = One Character).
Notes:
• The One Character Disconnect is intended for situations where
the destination port should not receive the disconnect command.
When the Three Character format is selected, the disconnect
sequence will pass through to the destination port prior to
breaking the connection.
When the Three Character format is selected, the disconnect
sequence will pass through to the destination port prior to
breaking the connection.
• When Three Character format is selected, the Resident
Disconnect uses the format "[Enter]LLL[Enter]", where L is the
selected Logoff Character.
selected Logoff Character.
• Inactivity Timeout: Enables and selects the Inactivity Timeout period for the
Network Port. If enabled, and the port does not receive or transmit data for the
specified time period, the port will disconnect. (Default = 5 Minutes).
• Command Echo: Enables or Disables the command echo for the Network
Port. (Default = On).