Alesis 03D Manual De Usuario

Chapter 7—Solo, Monitors & Meters

On the Moni.Setup page you can select the stereo output, aux sends, bus outs, or stereo 
cascade input as the monitor source. These signals are monitored via the monitor out 
and phones. Functions on this page do not affect the [SOLO] button or stereo output.

and PARAMETER wheel to set them.
If you are using a mouse, simply click the switches and drag the rotary control.

—These switches are used to select the signal source for 

the monitor out and phones. You can select the stereo out, aux sends, bus outs, and the 
stereo cascade input. When aux sends or bus outs are configured as stereo pairs, these 
switches are linked.

—These switches set the monitor signal source to pre-fader (PFL) or post-fader 

(AFL). This is a global setting that affects all monitor sources (i.e., stereo out, aux sends, 
etc).

—These switches set the monitor select mode. In LAST MONI mode, only 

one monitor source can be selected at a time. In MIX MONI mode, however, several 
monitor sources can be selected. Selected signals are mixed.

—This control is used to adjust the level of the monitor signal from 

–60 dB to +6 dB. This control can be adjusted using the PARAMETER wheel regardless 
of cursor position.

—This switch sets the monitor and phone’s signals to mono or ste-

reo. It functions independently of the MONO switch on the Solo Setup page. When on, 
the left and right signals are summed together to form a mono mix. The level of the 
summed mix is attenuated –3 dB.