Yamaha 01V96i Manual De Usuario
34
Bus Outs
01V96i—Reference Manual
2
F.S
This button determines whether Aux Sends follow the
Input Channel Surround Pan when the 01V96i is in any
Surround mode other than “Stereo.” When this button is
turned on, Aux Sends follow the Input Channel Surround
Pan. This is useful for feeding Surround signals to exter-
nal Surround effects processors.
This button determines whether Aux Sends follow the
Input Channel Surround Pan when the 01V96i is in any
Surround mode other than “Stereo.” When this button is
turned on, Aux Sends follow the Input Channel Surround
Pan. This is useful for feeding Surround signals to exter-
nal Surround effects processors.
2.
Move the cursor to the MONOx2 button for
the desired Bus or Aux Send, then press
[ENTER].
the desired Bus or Aux Send, then press
[ENTER].
The buses or Aux Sends are paired.
3.
To cancel a pair, move the cursor to the STE-
REO button for the desired Bus or Aux Send,
then press [ENTER].
REO button for the desired Bus or Aux Send,
then press [ENTER].
Attenuating Output
Signals
Signals
To attenuate the 01V96i’s output signals, display the EQ | Out
Att page and adjust the Stereo Out and Bus Out 1–8 attenua-
tors individually.
If necessary, you can also select Output and I/O card channels
and specify the amount of attenuation. This technique is con-
venient when you want to attenuate output signals quickly,
regardless of the source signal patching.
Att page and adjust the Stereo Out and Bus Out 1–8 attenua-
tors individually.
If necessary, you can also select Output and I/O card channels
and specify the amount of attenuation. This technique is con-
venient when you want to attenuate output signals quickly,
regardless of the source signal patching.
1.
Press the DISPLAY ACCESS [DIO/SETUP] but-
ton repeatedly until the DIO/Setup | Output
Att page appears.
ton repeatedly until the DIO/Setup | Output
Att page appears.
2.
Move the cursor in the left column (
1
), then
scroll the list up or down using the Parameter
wheel to select the desired output or slot
channel for which you want to adjust attenu-
ation.
wheel to select the desired output or slot
channel for which you want to adjust attenu-
ation.
The following outputs and slot channels can be selected:
• STEREO OUT L/R ................ STEREO OUT L & R
channels
• MONITOR OUT L/R............ MONITOR OUT L & R
channels
• OMNI OUT 1–4 ..................... OMNI OUT connectors
1–4
• SLOT OUT 1–1 through 1–16
..................... Slot channels 1–16
• ADAT OUT 1–8 ..................... ADAT OUT channels 1–8
• 2TR OUT DIGITAL L/R...... 2TR OUT DIGITAL L & R
• 2TR OUT DIGITAL L/R...... 2TR OUT DIGITAL L & R
channels
3.
Move the cursor to the parameter value in the
right column (
right column (
2
), then rotate the Parameter
wheel or press the [INC]/[DEC] buttons to set
the amount of attenuation.
the amount of attenuation.
The amount of attenuation can be set from 0 dB to –9 dB.
Tip:
To reset the attenuation amount of all Output Channels
to 0 dB, move the cursor to the INITIALIZE button, then
press [ENTER].
press [ENTER].
1
2