Harbor Freight Tools 66787 Manual Del Producto

Page 11

SKU 66787

Note:  For additional information regarding 

the parts listed in the following pages, 

refer to the Assembly Diagram near 

the end of this manual.

IMPORTANT:  This Welder requires 

1. 

the attachment and use of a 

electrical power cord plug (not 

included).  Only a qualified electrician 

should install the Power Cord Plug.  

Never remove the grounding prong or 

modify the Plug in any way.  Do not 

use adapter plugs with this Welder.
Connect the Ground Clamp (9) Cable 

2. 

to the NEGATIVE (-) terminal. 

(See Figure a.)
Connect the Electrode Holder (8) 

3. 

Cable to the POSITIVE (+) terminal. 

(See Figure a.)   

Designate a work area that is clean 

1. 

and well-lit.  The work area must not 

allow access by children or pets to 

prevent injury and distraction.
Route the Power Cord (17) along a 

2. 

safe route to reach the work area 

without creating a tripping hazard 

or exposing the Power Cord to pos-

sible damage.  The Power Cord must 

reach the work area with enough 

extra length to allow free movement 

while working.
Secure loose work pieces using a 

3. 

vise or clamps (not included) to pre-

vent movement while working.  The 

work pieces should be firmly held to-

gether and in position while welding.    

The distance (if any) between the 

two work pieces must be controlled 

properly to allow the weld to hold 

both sides securely while allowing the 

weld to penetrate fully into the joint.
There must not be hazardous ob-

4. 

jects, such as utility lines or foreign 

objects, nearby that will present a 

hazard while working.
A barrier, such as a welding curtain 

5. 

or welding shroud should be put up 

to protect others in the work area and 

limit the spray of sparks.

REV 09h