Ridgid R3001 Manual De Usuario

13

The reciprocating saw is equipped with externally 

accessible brushes.
n

  Unplug the saw.

Failure to unplug the tool could result in accidental 
starting causing possible serious injury.

     NOTE: Brush caps (2) are located on the top and bottom 

of the motor housing in front of the handle.

n

  Remove brush caps (2) using a screwdriver.

n

  Remove brush assemblies (2).

n

  Check for wear. Replace both brush assemblies when 

either has less than 1/4 in. length of carbon remaining.

    

NOTE:  Do  not  replace  one  side  without  replacing  the 
other.

n

  Reassemble  using  new  brush  assemblies.  Make  sure 

curvature of brush matches curvature of motor and that 
brush moves freely in brush tube.

n

Reassemble by reversing the steps listed above.

n

Tighten all brush caps securely. 

Do not over tighten.

Fig. 8