Festool PD574447 Manual De Usuario

12 

Domino XL DF700

The optional Cross Stops extend the position of the locat-

ing pins for wider tenon spacing. These are also adjustable 

so the spacing can be tailored to the needs of the specific 

application. 

 Note: The two Cross Stops are specific for right and 

left-hand mounting, such that the locking levers point 

toward the rear when locked. If you install the adjust-

able stop pins backward, the locking levers will point 

forward when locked, and this will interfere with the 

workpiece. If this happens, remove the stop pins from 

the outrigger arms and turn them around.

Mounting 

Tab and Slot

Lock

1.  With the locking handle rotated toward the front of the 

joiner (as shown in the upper photograph) insert the 

mounting tab into the slot from below.

2.  Turn the locking lever toward the rear to lock the Cross 

Stop to the base of the joiner.

3.  Loosen the clamping knob on the adjustable stop pin and 

slide the pin to the desired position. 

4.  Before tightening the clamping knob, make sure both 

pointers on the locating pin are pointing to the same 

measurement on the outrigger arm.

The new model Cross Stop is compatible with both DF 500 

and DF 700 joiners by inverting the stop pin assembly. This 

changes the height of the stop pins to line up with existing 

mortises. (The previous model will still fit the DF 700 joiner, 

but the pins won’t line up with existing mortises.) 
To invert the stop pin, loosen the clamping knob far enough 

to allow the rear clamp to rotate, then rotate the rear clamp 

180°, and retighten the clamping knob. The front of the 

stop pin assembly indicates which position is for the respec-

tive joiner. 

To ensure that the stop pins are centered on either side of 

the mortise location, they can be calibrated to the Domino 

machine to which they are attached. If the stop pins are not 

centered about the mortise location of the machine, loosen 

the locking setscrew and rotate the eccentric adjuster 

slightly. When the screw slot is vertical, the eccentric is in 

the neutral position. When the screw slot is horizontal, the 

eccentric is in the maximum offset toward or away from the 

mortise position. (A stamped “0” indicates the minimum 

offset of the eccentric.)

DF700

DF500

Eccentric 

Adjuster

Locking 

Setscrew

Clamping 

Knob

Rear 

Clamp

The side of the fence body contains a pair of alignment 

marks to indicate the vertical position of the mortising 

location. These marks are helpful for identifying the mortise 

location when plunging into the face of a large flat work-

piece. Use these to align the joiner with a pencil line that 

represents the desired center of the mortise location.
These can also be used in conjunction with the horizontal 

alignment mark on the base of the joiner to position a 

mortise at the intersection of two lines.

Alignment 

Mark