Festool PD574447 Manual De Usuario

Supplemental Owner’s Manual 

13

The optional Trim Stop is used to securely hold small work-

pieces for cutting mortises. 

1.  With the fence tilted to 90 degrees, slide the Trim Stop 

over the fence face of the Domino joiner as shown. Make 

sure the Trim Stop is fully seated onto the joiner’s fence.

2.  Slide the two latch tabs inward.
3.  Tighten the two thumbscrews.

1.  Loosen the two green thumbscrews on the bottom of the 

Trim Stop.

2.  Place the workpiece between the two guides and slide the 

guides inward.

3.  Use the position gauge on the Domino joiner fence face 

to center the workpiece.

4.  With the side guides tight to the workpiece and the 

workpiece centered in the position gauge, tighten the two 

thumbscrews.

  Hint: Make note of where the workpiece lines up 

on the sight gauge, and use the sight gauge when 

cutting the mortise on the mating frame for a T-joint 

frame.

Locked 

Position

Thumbscrew

Latch

Thumbscrews

Workpiece

Sight 

Gauge

The optional hand rail fence is used to help stabilize rounded 

workpieces that won’t otherwise rest flat against the fence.

1.  With the fence tilted to 90 degrees, slide the hand rail 

fence over the fence face of the Domino joiner as shown. 

Make sure the hand rail fence is fully seated onto the 

joiner’s fence.

2.  Slide the two latch tabs inward.
3.  Tighten the two thumbscrews.

Locked 

Position

Thumbscrew

Latch

If the hand rail fence is not sitting perfectly centered on the 

mortising location, it can be shifted to the side by adjusting 

the four gib screws.

Round 

Stock

Gib Screws (4)