OKI CX3641 MFP Manual De Usuario

7. Use the three screws provided to attach the fax 

board to the printer.

8. Attach the fax board cable to the connector 

labeled J470 FAX CONNECTOR (1) on the 

printer board.

9. Remove the tape mask from the LINE jack on 

the side of the printer.

10. Close the access 

door and tighten the 

thumbscrews.

The ferrite core is an FCC requirement.

In order to reduce electromagnetic interference—

“noise” that interferes with TVs or other 

appliances —you must place the included ferrite 

core on the telephone cable.

11. Snap the ferrite core onto one end of the 

telephone cable, then plug that end of the cable 

into the LINE jack on the side of the printer. 

Attach the other end of the cable to the phone 

line.

12. Peel the backing off the self-adhesive FCC label 

and attach it to the back of the printer.

13. Carefully push the printer back into the unit. 

and reattach it to the bumper brackets on the 

stand.

14. If you have the optional finisher, push it back 

onto the printer until it latches.

15. Turn the scanner and the printer back on.

See the “FAX“ section in your Advanced Technical 

User’s Guide for information on walk-up faxing.