Samsung SCX-5835NX Manual De Usuario

Media and tray_ 38

The tray is preset to Letter or A4 size, depending on your country. To 

change the size, you need to adjust the paper guides.
1. Push the back plate of the tray outwards completely so that it can extend 

the length of the tray.

2. Squeeze the paper length guide and slide it to the correct position for the 

paper size you are loading, which is marked at the bottom of the tray.

3. Flex or fan the edge of the paper stack to separate the pages before 

loading originals.

4. After inserting paper into the tray, squeeze the paper width guides and 

slide them to the desired paper size marked at the bottom of the tray.

•

Do not push the paper width guide too far causing the media to 

warp. 

•

If you do not adjust the paper width guide, it may cause paper 

jams.

Load the print media you use for the majority of your print jobs into tray 1. 

Tray 1 can hold a maximum of 500 sheets of plain paper. 
You can purchase an optional tray and attach it below the standard tray to 

load an additional 500 sheets of plain paper. (See "Available supplies" on 

Using photographic paper or coated paper may cause problems, 

requiring repairs. Such repairs are not covered by the warranty or 

service agreements.

1. Pull out tray. And adjust the tray size to the media size you are loading. 

2. Flex or fan the edge of the paper stack to separate the pages before 

loading originals.

3. Place paper with the side you want to print facing down.

Paper quantity indicator shows the amount of paper in the tray. 

4. When you print a document, set the paper type and size for the tray.

For information about setting the paper type and size on the control 

panel. (See "Setting the paper size and type" on page 42.)

•

If you experience problems with paper feeding, check whether 

the paper meets the media specification. Then, try placing one 

sheet at a time in the multi-purpose tray. (See "Print media 

•

The settings made from the machine driver override the 

settings on the control panel.