StorCase Technology DX115 Manual De Usuario

Introduction

5

DX115 for Backup User's Guide - Rev. A01

StorCase Technology, Inc.

• Power Switch (cont'd)

OFF  -

Press and hold down switch until the Drive Ready LED starts to flash.  Drive
is ready to be removed when the Drive Ready LED is OFF.

ON *   -

Press and hold down switch until the Drive Ready LED starts to flash.  Drive
is ready to be accessed when the Drive Ready LED is ON.

* Only necessary if:

1.

Drive is inserted into the receiving frame after a system power-up.

2.

Drive was removed and inserted while system is powered on.

• Drive Ready/Error LED - This bi-color LED indicates the status of the drive , fan, or DC

power, depending on the color.

Drive Ready (Blue):

Flashing blue LED indicates that drive is inserted and powering up.

Steady blue LED glow indicates drive is powered on and ready for access.

Error  (Red):

Flashing red and blue LED indicates a fan failure.

Steady red LED glow indicates DC power failure.

Flashing red LED indicates a SAS drive inserted into the receiving frame (SAS
drives are not supported).

• Drive Activity LED - This amber LED indicates when the host computer is accessing the

data on the drive.  LED will flash during communication with the host computer.

Some SATA PC systems/host controllers provide support for the Drive Activity LED
feature (refer to the SATA PC system/host controller manufacturer's documentation for
further information).

Drive Activity LED can be enabled via host connection (cable not included) to Pin 1 located
on Receiving Frame Motherboard (Figure 2).  Refer to the SATA PC system/host control-
ler manufacturer's documentation for further information.

• Fan Error LED Disable Switch - This switch allows the user to disable the Fan Error

LED (by inserting a paper clip or similar object to activate switch).

StorCase recommends replacing a faulty fan immediately.  Contact StorCase for spare
fan ordering information.