Cisco Systems 1550 Manual De Usuario

Connect a CAT5e or better Ethernet cable from your wired LAN network to the power injector.

To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord. Statement 1023

Use only the 1500 power injector (AIR-PWRINJ1500-2=) for the access point. This power injector is 
designed to meet the power requirements of the access point and is a listed Class 2 limited power source 
(LPS). 

The installer is responsible for ensuring that powering the access point from this type of power injector 
is allowed by local and/or national safety and telecommunications equipment standards.

To forward bridge traffic, add a switch between the power injector and controller. Refer to the 
Cisco Wireless Mesh Access Points, Design and Deployment Guide, Release 7.0 for more 
information. 

Ensure that the antennas are connected and that a ground is attached to the access point before you apply 
power to the access point.

Connect a shielded outdoor-rated Ethernet (CAT5e or better) cable between the power injector and the 
PoE-in connector of the access point (see 

Connect the Ethernet cable to the access point PoE-In port (see 

When a 1552E or1552EU access point is powered by PoE, the PoE-Out port is not active.

Continue with 

.

You need to supply these tools and materials:

Shielded outdoor-rated Ethernet (CAT5e or better) cable with 0.2 to 0.35 in. (0.51 to 0.89 cm) 
diameter

The PoE-out port is disabled when the access point is powered by the power injector.

RJ-45 connector and installation tool

Adjustable wrench

To connect the shielded Ethernet cable to the access point, follow these steps:

Disconnect power to the power injector, and ensure all power sources to the access point are turned off.