Cisco Systems 1550 Manual De Usuario
2-47
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-24247-01
Chapter 2 Installing the Access Point
Powering the Access Point
Warning
This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
de-energize the unit. Statement 1028
Note
If your access point contains a backup battery pack, you must press the reset button for 10
seconds or more (see the
seconds or more (see the
Step 2
Ensure a 6 AWG ground wire is connected to the access point (see the
Step 3
Use an adjustable wrench, a 22-mm socket, or the Sealcon S-2200-WR wrench to remove the Ethernet
connector plug from the access point (see
connector plug from the access point (see
for the location).
Figure 2-34
Location of Ethernet Liquid-Tight Adapters (Only Models AIR-CAP1552E-x-K9 and
AIR-CAP1552EU-x-K9)
AIR-CAP1552EU-x-K9)
Note
For information on data cable entry, refer to
Step 4
Loosen the round end of the liquid-tight adapter by turning counterclockwise, but do not remove (see
1
PoE-in port
2
PoE-out port
4
5
6
255260
1
2