Fujitsu P3NK-4452-01ENZD Manual De Usuario

XG Series User's Guide

Chapter 3 Installation

Workflow for Initial Setup of the Device

To operate in conjunction with an SNMP manager, the SNMP agent must be configured.

To configure the SNMP agent, carry out the following procedures in "admin" Operation mode.

XG2600# configure

Switch to Configuration mode.

XG2600(config)# snmp service on

Enable SNMP function.

XG2600(config)# snmp agent contact SYSTEM-
CONTAC

Set the swith's contact (SYSTEM-CONTACT).

XG2600(config)# snmp agent location SYSTEM-
LOCATION

Set the swith's location (SYSTEM-LOCATION).

XG2600(config)# snmp agent address A.B.C.D

Set the SNMP agent address. This setting is also used for the local 
address at trap transmission.
Make sure to set it when using the SNMP agent function

XG2600(config)# snmp manager 0 A.B.C.D 
COMMUNIT-YNAME v2c disable

Set the IP address (host name) of the SNMP manager, the commu-
nity name, sending SNMPv2 traps, and disabling writing. if the SNMP 
trap notification is enabled.

XG2600(config)# commit

Apply the configuration.

XG2600(config)# save

Save the configuration.

XG2600(config)# exit

Switch to Operation mode.

XG2600# configure

Switch to Configuration mode.

XG2600(config)# snmp service on

Enable SNMP function.