Black Box Multi DVI System CATX Series Manual De Usuario
14
CHAPTER 3: Setup and Installation
3. Setup and Installation
3.1 Cabling Considerations
• We recommend mounting and connecting all cabling to the Multi DVI System
components before applying power. Please note recommended power sequence below.
components before applying power. Please note recommended power sequence below.
3.2 Making the Connections
3.2.1 Connections and Setup in General
This section contains figures showing connections with the specific Multi DVI System
models. In general, however, the connection and setup procedure at both transmitter
and receiver ends is as follows:
models. In general, however, the connection and setup procedure at both transmitter
and receiver ends is as follows:
At the transmitter end:
1. Connect the source video to the Multi DVI System transmitter video input port, which
is a DVI connector labeled DVI IN.
is a DVI connector labeled DVI IN.
2. If desired, attach a local monitor via the local monitor port to DVI OUT.
3. Connect the CAT5 cable to the transmitter.
4. Do not apply power to the transmitter at this time.
At the receiver end:
1. Connect the DVI OUT connector to the display unit,.
2. Make sure that the Cat5 cable connection from the transmitter or receiver are secure.
3. Apply power to the display, then to the receiver.
4. Next, the transmitter should be powered on and finally the video source signal.
Reference Appendix B for Link status and LED indicator explanations.
4. Next, the transmitter should be powered on and finally the video source signal.
Reference Appendix B for Link status and LED indicator explanations.
If there are any problems at either end, see Chapter 4.
5
MULTI DVI SYSTEM.
3
3.2.2 CONNECTIONS ON THE SINGLE-PORT MULTI DVI
The AC1100A, AC1101A, AC1112A units support DVI video over CAT5 cable .
Figure 3-1 shows the video only Multi DVI System Transmitter connections, and Figure
3-2 shows the receiver connections.
Figure 3-1. Transmitter connections on the AC1100A.
Figure 3-2. Receiver connections on the AC1101A.
6