Black Box VX-HDMI-POE-UTX Manual De Usuario
724-746-5500 | blackbox.com
Page 26
Chapter 5: Advanced Commands
Figure 5-2. Current configured parameters list.
To reset to factory default, setting the IP mode to autoip and removing any
overrides, type in:
reset_to_default.sh
To change the baud rate of the serial extension interface, type in:
stty X –F /dev/ttyS0
overrides, type in:
reset_to_default.sh
To change the baud rate of the serial extension interface, type in:
stty X –F /dev/ttyS0
(replace X with desired baud rate)
To disable/enable the link for a specific device, type in:
ast_send_event -1 e_stop_link
ast_send_event -1 e_reconnect
To disable/enable the link for a specific device, type in:
ast_send_event -1 e_stop_link
ast_send_event -1 e_reconnect
5.1 Advanced IP Commands
Each device has three possible modes of establishing an IP address: autoip, dhcp,
and static.
1. AutoIP is the default mode and it will always automatically assign available IP
and static.
1. AutoIP is the default mode and it will always automatically assign available IP
addresses in the private IP domain 169.254.xxx.xxx
NOTE: The MediaCento IPX uses the Avahi zeroconf protocol to find an available IP
in the 169.254.xxx.xxx range.