Black Box VX-HDMI-POE-UTX Manual De Usuario
724-746-5500 | blackbox.com
Page 27
Chapter 5: Advanced Commands
2. DHCP client gets an address from the local DHCP server.
CAUTION: Make sure a DHCP client is connected or problems will occur.
3. Static allows you to manually change the IP address and netmask of the device.
CAUTION: Make sure a DHCP client is connected or problems will occur.
3. Static allows you to manually change the IP address and netmask of the device.
This requires further input before reboot.
To change the IP mode, type in:
astparam s ip_mode <mode>
astparam s ip_mode <mode>
(where <mode> is autoip, dhcp, or static)
astparam save
(saves changes)
reboot
(reboots the device)
If static is selected, the following commands are needed before reboot. Type in:
astparam s ipaddr xxx.xxx.xxx.xxx
astparam s ipaddr xxx.xxx.xxx.xxx
(enter IP address for x’s)
astparam s netmask xxx.xxx.xxx.xxx (enter netmast for x’s)
astparam save
astparam save
(saves changes)
reboot
Figure 5-3. COM1 PuTTY screen.
5.2 Advanced Multicast IP Configuration
Predefined multicast addresses can be selected by using the rotary switch buttons
on the devices (recommended). See Table 5-1 for listing of channels:
on the devices (recommended). See Table 5-1 for listing of channels: