ATTO Technology 2500C Manual De Usuario
23
ATTO Technology Inc. iPBridge Installation and Operation Manual
3.1 ExpressNAV pages
Each page in the ATTO ExpressNAV interface provides information and/or configuration parameters
based on a specific topic. Each page can be reached through the menu at the side of each page. An image
on each page’s header shows each port in the product faceplate. Each port is clickable and takes you to
the appropriate page.
Status
based on a specific topic. Each page can be reached through the menu at the side of each page. An image
on each page’s header shows each port in the product faceplate. Each port is clickable and takes you to
the appropriate page.
Status
Displays iPBridge information:
• Vendor ID, product ID, firmware revision number
and serial number
• Valid temperature range, current temperature
and current voltage
• Ethernet port IP addresses and status
Serial Port Configuration
Configures the baud rate and echo parameters. Refer to
details on each option.
Time & Date Configuration
Configures the real-time clock or accesses a remote
time server. Configurable options are:
time server. Configurable options are:
• Enable/disable Simple Network Time Protocol
• Time Server and time zone
• Manually set time and manually set date
• Time Server and time zone
• Manually set time and manually set date
Refer to
on page 41 for
details each parameter.
Ethernet Port Configuration
Configures each port independently for the following
parameters:
parameters:
• Enable/disable
DHCP
• IP address, gateway, subnet mask and Ethernet
speed
• MTU
For NDMP configurations only
• NDMP max. version and NDMP port number
Refer to
page 51 for details.
SCSI Configuration
Configures each port independently for the following
parameters:
parameters:
• Bus
speed
• Enable/disable
sync
transfer
• Enable/disable
wide
transfer
• Initiator
ID
• Enabled/disable
bus reset on startup
• Enable/disable
bus
termination
Attached devices are listed for each bus and you can
reset each port from this screen.
Refer to
reset each port from this screen.
Refer to
iSCSI Configuration
Defines the iSCSI CHAP target name, account name
and secret and configures the following parameters:
and secret and configures the following parameters:
• iSCSI
Alias
• iSCSI
Port
Number
• Enable/disable
iSNSLoginControl
• Enable/disable Multi Target Mode
• Enable/disable
• Enable/disable
SpeedWrite
• Enable/disable
CHAP
settings: direction (in or
out)
Refer to
on page 55 for details on
each parameter.
Bridge Configuration
Defines a name for the bridge, sets an admin user name
and password, a read only user name and password,
restores defaults or configures the following
parameters:
and password, a read only user name and password,
restores defaults or configures the following
parameters:
• Minimum and maximum operating temperature
• Operating
• Operating
temperature
warning
• Enable/disable
Identify
Bridge
For NDMP configurations only
• NDMP authorization type
Refer to
on page 41 for
details on each parameter.
Mapping
Maps drives. If in Multiple Target mode in an iSCSI
model, you may choose, add or delete an iSCSI target.
Refer to
model, you may choose, add or delete an iSCSI target.
Refer to
Mapping
commands
on page 57 for details.
Advanced CLI Configuration
Allows you to input any CLI command available
through the iPBridge. See Exhibit 3.1-1 for an
example.
through the iPBridge. See Exhibit 3.1-1 for an
example.
1
Type in the CLI command
2
Click the Submit button.