Cisco Systems WAVE594K9 Manual De Usuario

4-2

Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide

OL-24619-02

Chapter 4 Installing Hardware Options for the WAVE-594 and WAVE-694

Replacing a Hard Disk Drive/Solid State Drive

Step 1

Review the information in the

“Safety Warnings and Cautions” section on page 2-1

and the

“Safety

Guidelines” section on page 2-2

Step 2

Power down the appliance.

Note

You must power down the appliance before installing or removing an Interface Module. Interface
Modules are not hot-swappable.

Step 3

Locate the Interface Module slot in the appliance chassis and slide the Cisco Interface Module into the
slot until the ejector lever is seated.

To remove an Interface Module, first use the ejector lever to unlatch and then pull out the Interface
Module. (See

Figure 4-1

Figure 4-1

Interface Module—Removal

Step 4

Power on the appliance.

Step 5

For information about connecting cables to the Cisco WAVE Interface Module ports, see

Chapter 5,

“WAVE Interface Modules.”

Replacing a Hard Disk Drive/Solid State Drive

The WAVE appliance supports as many as two 2.5-inch (Small Form Factor) hard drives. The WAVE-594
supports SATA drives and the WAVE-694 supports SAS drives.

24655