Cisco Systems WAVE594K9 Manual De Usuario
4-3
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
OL-24619-02
Chapter 4 Installing Hardware Options for the WAVE-594 and WAVE-694
Replacing a Hard Disk Drive/Solid State Drive
Note
The WAVE-594 supports both Solid State Drives and Hard Disk Drives. You cannot mix HDD and SSD
in the same chasis.
in the same chasis.
For details about the WAVE-594 appliance specifications, see
.
Hard drives are hot-swappable therefore it is not necessary to power the system down before installing
or replacing.
or replacing.
When removing hard drives from the WAVE appliance, observe the following general guidelines:
•
The system automatically sets all drive numbers.
•
Drives must be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
grouped together into the same drive array.
Note
All hard disk drives being used in the appliance must be identical.
Caution
To maintain proper system cooling, do not operate the appliance for more than 1 minute without either
a hard disk drive or a filler panel installed in each bay.
a hard disk drive or a filler panel installed in each bay.
To replace a hard disk drive in a bay, follow these steps:
Step 1
Review the information in the
and the
.
Step 2
Press the button and swing the handle out. (See
Note
Wait 5 seconds before removing to let the disk spin down.
Figure 4-2
Removing a Hard Disk Drive
Step 3
After waiting 5 seconds, pull the handle to remove the drive assembly from the bay.
246552
1
2
3