Cisco Systems 3545 PRI Manual De Usuario

Connect the 

supplied terminal

 cable to the PC terminal.

Connect the power cable.

Start the terminal emulation application on the PC.

Set the communication settings in the terminal emulation application on the PC as follows:

Baud rate: 9600

Data bits: 8

Parity: None

Stop bits: 1

Flow control: None

Turn on the power to the gateway.

After the terminal emulator session starts, press the RST button on the gateway front panel to reset the 
module.

A log of the auto-boot events and a VxWorks banner scrolls across the computer monitor.

When the gateway is started for the first time, two VxWorks banners appear. The configuration 
option appears after the second banner.

When the message “Press any key to start configuration” appears on the screen, press any key within 6 
seconds. 

The network configuration Main menu displays:

Press any Key To start configuration...

Main menu

Enter <N> to configure default network port values

Enter <P> to change the configuration software password

Enter <A> to display advanced configuration menu

Enter <Q> to quit configuration menu and start GW

If you do not press a key before the countdown ends, the device continues its initialization and 
you can only configure the device by pressing the RST button on the front panel.          

At the prompt, type N to configure default network port values and press Enter. 

At the Enter IP address for default interface prompt, type the IP address you want to assign to the 
gateway and press Enter. 

PC with available serial port and 
terminal emulator software installed

RS-232 terminal cable (shipped with 
the unit)