Cisco Systems 3545 PRI Manual De Usuario

Do not use leading zeros in the IP address.

At the Enter Default Router IP Address prompt, type the IP address of the router associated with the 
segment in which the unit will be installed and press Enter. 

Do not use leading zeros in the IP address.

At the Enter IP Mask for default device prompt, type the subnet mask without leading zeros, and then 
press Enter. If a subnet mask is not used, press Enter.

Allow the unit to complete the reboot process. A new emulator session begins.

Close the terminal emulator session.

Use the serial port to set the Ethernet speed and duplex parameters that you want the Cisco Unified 
Videoconferencing 3500 Gateway to use. 

Access the gateway through the serial port and start a terminal emulator session.

If the gateway is already running, you need to reboot or restart the device.

When the message “Press any key to start configuration” appears on the screen, press any key within 6 
seconds. 

The network configuration Main menu appears.

At the prompt, enter A to display the Advanced Configuration menu and press Enter.

The Advanced Configuration menu appears.

At the prompt, enter 3 to select “Change LAN port Settings” and press Enter.

At the prompt, enter the number or letter for one of the following:

1 - 10Mbps Half Duplex

2 - 100Mbps Half Duplex

3 - 10Mbps Full Duplex

4 - 100Mbps Full Duplex

5 - Auto

Q - Quit

We recommend that you select “5 - Auto” here and also set the Port settings option to “Auto” in 
the gateway web user interface at Gateway > Board > Addressing.