Cabletron Systems HSIM-W6 Manual De Usuario
HSIM-W6 User’s Guide
49
5
Installation
This chapter outlines the procedure for attaching the HSIM-W6 to the network. To install the
HSIM and WPIMs, you need the following items:
HSIM and WPIMs, you need the following items:
•
Antistatic wrist strap (provided with the HSIM-W6)
•
Phillips screwdriver
Unpacking the HSIM-W6
Unpack the HSIM-W6 as follows:
1.
Remove the shipping material covering the HSIM-W6 in the shipping box.
2.
Carefully remove the HSIM-W6 from the shipping box. Leave the module in its
non-conductive bag until you are ready to install it.
non-conductive bag until you are ready to install it.
3.
Attach the antistatic wrist strap (refer to the instructions on the antistatic wrist strap package).
4.
After removing the module from its non-conductive bag, visually inspect the device. If there
are any signs of damage, contact Cabletron Systems (refer to
are any signs of damage, contact Cabletron Systems (refer to
)
immediately.
Guidelines for Installations
Installation sites must be within reach of the network cabling and meet the requirements listed
below:
below:
•
A properly grounded power receptacle must be within seven feet of the location.
•
In a shelf installation, the shelf must be able to support 13.6 kg (30 lb) of static weight for each
device on the shelf.
device on the shelf.
Only qualified personnel should perform installation procedures.