Cabletron Systems HSIM-G01 Manual De Usuario

 

Installation

 

You can install an HSIM-G in any Cabletron Systems device that supports 
HSIM technology (e.g., 2E42-27, 6E132-25).

The following sections provide instructions for installing an HSIM-G in 
an interface module or in a standalone device. Refer to your specific 
interface module or standalone device documentation for exact HSIM slot 
and connector locations. Refer to 

 to install the HSIM-G in 

an interface module, and 

 to install the HSIM-G in a 

standalone device. 

 

To install an HSIM-G in an interface module that supports HSIM 
technology, perform the following steps.

 

Disconnect any network cables connected to the ports of the interface 
module.

 

Attach the antistatic wrist strap (refer to the instructions outlined on 
the interface module User’s Guide).

 

If the module is in a chassis, unlock the top and bottom plastic locking 
tabs of the module faceplate, and remove the module from the chassis.

 

Lay the module down with the internal components facing up.

 

and the HSIM coverplate. Save the screws.

 

screws.

 

Refer to the release notes for the version of firmware running 
on the host platform to ensure that the HSIM-G is supported. 
“Host platform” is used to designate the interface module or 
standalone device into which the HSIM-G is installed.

 

Note the ports of the interface module that have cables 
attached to them. Write down the port numbers and label the 
cables to make it easier to reattach the network properly after 
the installation.