Samsung RIF-BT10 Manual De Usuario

                                                     

      

 
 

5

 

      1) Virtual serial port driver installation 

 

      - Connect Bluetooth main (master) to USB port of PC 

 

            - Found New Hardware Wizard detects new hardware by Plug and Play and select Include this 

location in the search. Then select the folder which contains 

 

            - When installation completes, Found New Hardware Wizard will detects new hardware once again. 

Then repeat the above setting one more time. 

            - Refer to Attachment 1.

 

 

      2) Virtual serial port driver setting 

 

            - Check Virtual port and apply the setting as below. 

            - Start > Control Panel > System > Hardware > Device Manager 

            - Select USB Serial Port under Port (COM x: Port number varies from your PC condition) and change 

the Properties. 

            - Port Setting: 

 

      - Advanced Setting: 

 

                                                  Check in 

 and 

 

            - Make sure not to change COM Port Number (When changes, select the open port) 

            - Refer to Attachment 2. 

 

 

      3) Bluetooth & Printer dip switch setting 

            - Set Maser/Slave, Baud rate and handshaking by Dip switch. 

            - 

 bps, 

 (Be sure that communication condition must be all the same for 

  PC, Bluetooth master, Bluetooth slave, Printer) 

 

            - Refer to Attachment 3. 

 

 

4) Bluetooth slave setting 

            - Connect Bluetooth main (master/slave) to USB (or Serial) port of PC. 

      - Execute 

from the downloaded files

 

      - Select the virtual port 

a) USB port: Select the virtual port (COM x) of step 2). 

b) Serial (RS-232C): Select the COM x connected. 

      - Configure Adapter setting: 

slave, 19200, hardware 

- Disconnect the Bluetooth main (master/slave) from the PC, assemble it with the Cover_BT, and   

connect it to the printer. 

- Refer to Attachment 4.