3com 3C990B-TX-M Manual De Usuario
6 Installing NetWare Drivers
72
wait timeout
This command sets the timeout value, in seconds, that the software waits before marking
a NIC that is in wait mode as failed (see retry count). If no argument is specified or if the
specified argument is invalid, the current value is displayed. Otherwise, the new value is
displayed.
This command sets the timeout value, in seconds, that the software waits before marking
a NIC that is in wait mode as failed (see retry count). If no argument is specified or if the
specified argument is invalid, the current value is displayed. Otherwise, the new value is
displayed.
Troubleshooting a Group Configuration
Use the troubleshooting tip in the table below to solve problems that may occur in a
group configuration.
group configuration.
Syntax
lbrsl wait timeout
seconds
where:
seconds is any positive integer.
Example
lbrsl wait timeout 2
Default
1
NOTE: To access a database of technical information that can help you diagnose
and solve NIC installation, configuration, and upgrade problems, go to:
and solve NIC installation, configuration, and upgrade problems, go to:
http://knowledgebase.3com.com
Symptom
Tip
More than one non-3Com server NIC
has been detected in one or more
groups on this server.
has been detected in one or more
groups on this server.
You can use only one NIC that is not a 3Com server NIC in
one 3Com load balancing/RSL group per server. Check the
groups and remove all but one of the non-3Com server
NICs from the groups.
one 3Com load balancing/RSL group per server. Check the
groups and remove all but one of the non-3Com server
NICs from the groups.