Toshiba XLTR-200 Manual De Usuario

 

  

10

The gateway’s installation procedure will vary slightly depending on the chosen 
mounting method and the networks that will be used. 
 
 

The included standoff kit allows for panel mounting of the unit.  The standoff kit 
is comprised of four 1” aluminum male/female standoffs and four #6 lock 
washers. 
 
1.  Remove one of the four cover standoff retention screws and its lock 

washer from the bottom side of the unit.  DO NOT dispose of this screw 
and washer, as they will be used later to mount the unit to the panel. 

2.  Install one of the male/female standoffs and a #6 lock washer from the 

standoff kit through the unit’s circuit board and into the bottom of the cover 
standoff.  Refer to Figure 1. 

 

 

aluminum standoffs 

lock washers

lock washers 
and screws 
from step 1

 

gateway unit

panel

 

 

3.  Repeat steps 1 and 2 above to replace each of the three other cover 

standoff retention screws.