Toshiba XLTR-200 Manual De Usuario

 

  

11

4.  Using the dimensions provided in Figure 2, drill four 0.150” diameter holes 

at the specified locations on the panel.  As a convenient pattern guide, the 
unit with attached mounting standoffs can be held against the panel, and 
the four standoff locations marked with a pencil or scribe. 

 

4.0 IN 

3.5 IN

2.9 IN

4.0 IN

 

 
5.  As shown in Figure 1, use the four screws and lock washers from step 1 to 

mount the unit from the back side of the panel. 

 

The unit footprint measures 4” x 4” square, and is designed to fit directly into 
existing 4” Augat SnapTrack

TM

 (6TK series or equivalent).  Carefully insert the 

unit into the SnapTrack

TM

 by pressing firmly on the pan head screws located at 

the 4 corners of the unit’s cover.  DO NOT press directly on the aluminum 
cover, as this may damage the cover. 
 

An optional mounting kit (ICC part number 10581) allows DIN rail mounting of 
the unit.  The mounting kit is comprised of a 4” section of Augat 6TK 
SnapTrack

TM

 and two DIN rail clips. 

 
1.  Carefully insert the unit into the SnapTrack

TM

 by pressing firmly on the pan 

head screws located at the 4 corners of the unit’s cover.  DO NOT press 
directly on the aluminum cover, as this may damage the cover. 

2.  Install the DIN rail clips into the openings on the bottom side of the 

SnapTrack

TM

.  Refer to Figure 3.