Toshiba PROSEC T3H Manual De Usuario
42
PROSEC T3H
2. Expanded Functions
2.3.3
Ethernet
support
The Ethernet module (EN311) is available for the T3H. By using the EN311, the T3H
can be connected to Ethernet network.
Using the Ethernet module, the T3H supports the following communication functions.
•
Computer link function:
Host computer on the Ethernet can perform data read/write, T3H status read,
program up-load/down-load, etc. for the T3H, by using the T-series computer link
command.
Host computer on the Ethernet can perform data read/write, T3H status read,
program up-load/down-load, etc. for the T3H, by using the T-series computer link
command.
•
Peer-to-peer communication:
By using SEND and RECV instructions, any register data of a T3H can be sent to
other T3H, and any register data of other T3H can be read into a T3H, via
Ethernet.
By using SEND and RECV instructions, any register data of a T3H can be sent to
other T3H, and any register data of other T3H can be read into a T3H, via
Ethernet.
•
Socket service:
Communication between a computer and a T3H user program is available by using
SEND and RECV instructions. Maximum 8 ports of socket are available. The
protocol can be selected either TCP/IP or UDP/IP for each port.
Communication between a computer and a T3H user program is available by using
SEND and RECV instructions. Maximum 8 ports of socket are available. The
protocol can be selected either TCP/IP or UDP/IP for each port.
Up to four EN311’s can be installed on a T3H.
To activate the EN311, SEND instruction is required to set parameters (IP address,
UDP port number) and to send commands (communication start, etc.)
NOTE
(1) The Ethernet module (EN311) is under development.
(2) For details of the EN311, refer to the separate manual for EN311.
(2) For details of the EN311, refer to the separate manual for EN311.